Pahlén introduces a new line of high capacity heat exchangers for pools
Heat exchanger Aqua MEX is made of high quality materials, glass-fibre reinforced polypropylene and a new developed high effective coil made of titanium.Our new line gives the best possible heating capacity and resistance against aggressive water. Compact, fully equipped, easy to install and use. The heat exchanger has a straight flow with a low pressure drop and with slip connections for 63 mm pipes. Minimum flow on the secondary side (pool water) 90 l/min.
The heat exchanger is equipped with digital control, where the desired pool temperature can easily be set and the current pool temperature is shown in the LED display.
Aqua MEX fully equipped has a three-step single-phase built-in circulation pump for the primary (hot) water as well as built-in temperature sensor, flow switch and check valve. It is also equipped with two drain plugs on the secondary circuit (pool water) for easy drainage of the heat exchanger. If you choose our top model Aqua MEX fully equipped, you get a complete unit ready and simple to install.As an alternative to our fully equipped Aqua MEX we do also offer a standard version of this heat exchanger with stainless steel or titanium coil.
Aqua MEX is the most economical and easy option when it comes to installation and heating of your pool as it is connected directly to your hot water system.
Aqua MEX is a compact spiral heat exchanger of the highest quality. Available in standard or fully equipped.
|
Electronic digital control panel
- Built-in safety device turns off the heater at 45°C
- Optimized for low electrical consumption
- Easy setting of the desired pool temperature
- Clear figures show the pool water as well as the set temperature
- Display of heating in operation
|
 |
• Aqua MEX fully equipped comes complete with flow switch, check valve, temperature sensor, circulation pump and
electronics - Easy to install, plug and play.
• Three step single phase circulation pump
• Economic
• Rapid heating
• Capacity range 40, 70 and 100kW
• Digital control and display
• The housing and cabinet are made of glass-fibre reinforced polypropylene
• Electronic flow switch
• Straight flow 63 mm (2”) pipe
• New coil made of titanium
• Coil in stainless steel AISI 316L
• Installation together with any boilers, heat pumps, solar panels or other heat sources
• IP44 (International Protection Rating)
| Technical data Aqua MEX fully equipped |
| Item no. |
Model |
*Capacity |
Primary, hot water |
Secondary, pool water |
| |
|
kW |
kcal/h |
kBtu/h |
l/min |
Press. drop H(m) |
l/min |
Press. drop H(m) |
| 113951 |
AM-FE 40 |
40 |
34 400 |
135 |
20 |
0,6 |
250 |
0,4 |
| 113952 |
AM-FE 40T |
40 |
34 400 |
135 |
20 |
0,4 |
250 |
0,4 |
| 113953 |
AM-FE 70 |
70 |
60 200 |
240 |
30 |
1,6 |
300 |
0,6 |
| 113953 |
AM-FE 70T |
70 |
60 200 |
240 |
30 |
1,4 |
300 |
0,6 |
| Technical data Aqua MEX standard |
| 11316 |
AM 40 |
40 |
34 400 |
135 |
20 |
0,6 |
250 |
0,4 |
| 11326 |
AM 40T |
40 |
34 400 |
135 |
20 |
0,4 |
250 |
0,4 |
| 11317 |
AM 70 |
70 |
60 200 |
240 |
30 |
1,6 |
300 |
0,6 |
| 11327 |
AM 70T |
70 |
60 200 |
240 |
30 |
1,4 |
300 |
0,6 |
| 11318 |
AM 100 |
100 |
86 000 |
340 |
40 |
2,6 |
333 |
0,8 |
| 11328 |
AM 100T |
100 |
86 000 |
340 |
40 |
2,3 |
333 |
0,8 |
*Capacity at 60° temperature difference between primary (hot water) and secondary (pool water) temperature.
Heat Exchanger Aqua MEX
